Home / Blog / Causes and solutions of Wall Putty Blister

Causes and solutions of Wall Putty Blister

Views:12     Author:Site Editor     Publish Time: 2020-09-01      Origin:Site

The main reason for the blistering of Wall putty powder is the problem of the wall. If the wall is pitted, uneven, and has small pits, It must be blistered, and the amount of blistering depends on the shear force of hydroxypropyl methylcellulose. The higher the viscosity of cellulose, the more bubbles, and vice versa.

Because of the high viscosity and high surface tension, when the air pressed into the pit protrudes out, the bubbles formed are not easy to break.

   Use less shear force, it will be better. It can also be made with some vertical kettle technology. The viscosity is lower and the water retention is better. We, Hebei Landcel Cellulose, has special products that guarantee and ensure no foaming, less foaming, good water retention and workability.

   Putty powder blistering has a certain relationship with the base of the wall. If the maintenance period of the grassroots tumbler has not passed, the weak alkali will be very large, causing the putty layer to have a high weak alkali during the maintenance period, leaving traces of blistering after drying. If the base wall is too dry, also not good, and the speed is too fast when it is scraped, which causes the putty to laminate with gas and generate air drums. The HPMC and putty powder must be stirred completely,in order to completely dissolve the HPMC, gray calcium, heavy calcium and other additives, which can also prevent the putty powder from foaming.

The main ingredients in the putty powder are HPMC, RDP, white mud, double fly powder, heavy calcium powder, talcum powder and gray calcium powder, etc. The function of HPMC is thickening, water retention and good workability. It does not participate in any reaction.

  The reasons for the bubbles produced by putty can be divided into the following aspects: 1. Too much water. 2. If the bottom layer is not dry, just scrape another layer on it, which will also cause bubbles. The solution is to control the water in an appropriate amount to ensure that the bottom layer is dry and then the second time, the quality of the gray calcium powder should also be stable.

   The causes of bubbles and other problems caused by poor batching of putty powder should be examined for various reasons. HPMC is not the most important, but the construction technology is more important.

Hebei Landcel Cellulose Tech., is a professional manufacturer of HPMC,viscosity ranges from 300-75000 Mpa.S, Brookfield 2% solution, use MH100T could effectively solve the problem of wall putty blister.


Product Category

Contact us

Tel:+86-311-66600679
Email:info@landcel.com

BLOG

More >>
  • Introduction of Landcel HPMC

    Introduction of Landcel HPMCThe alias of Hydroxypropyl methyl cellulose is hypromellose; cellulose hydroxypropyl methyl ether, English abbreviation: HPMC, It uses cotton cellulose as raw material, and is produced by special etherification under alkaline conditions , the whole process is completed un

  • HPMC for Tile Mortars and Grouts

    Tile adhesives are cement and/or polymer dispersion-based systems. The rheological additives used for these are mainly cellulose ethers, which provide the right consistency for the application, sag resistance of wall tiles, water retention for the optimum hardening of cement, and the control of open

QUICK LINK

PRODUCTS

ADDRESS INFO

Tel : +86-311-66600679
Mobile Phone: +86-13780519211
Email: info@landcel.com
Add : C-2102 Wonder Mall Business Square, 15 Yuhua West Rd., Shijiazhuang 050000, Hebei, China
 
Copyright  2019 Hebei LandCel  Cellulose Tech  Co., Ltd.